Assembling Spouts On Portafilter, Universal

Assembling Spouts On Portafilter, Universal

Time Needed: <5 Minutes


Parts Needed:

46000-56120 Double Spout, Spouts Only
46000-56131 Portafilter Body, Body Only

Tools Needed: Screw Driver



Step 1: Insert driver into spouts of portafilter



Step 2: Rotate spouts using leverage from driver until spouts are tight and look as in the photo below:



If you have any questions or concerns, please contact support@slayerespresso.com


    • Related Articles

    • Portafilter Head Replacement

      Portafilter Handle Removal Procedure Install portafilter into the group head Grip the handle tightly and rotate in a counter clockwise direction Remove old portafilter head from group ​Install new portafilter head Install the new portafilter handle ...

    • Replacing Group Head Gasket - Universal

      Replacing Group Head Gasket Objective: Replace group head gasket per Slayer's recommended Preventative Maintenance schedule. All Slayer espresso machines and preventative maintenance kits feature 58mm x 6.1mm EPDM group head gaskets. Parts: ...

    • Slayer Crating Guide - Universal

      Slayer Uninstall & Recrating Guide 2023 Only qualified service personnel should uninstall Slayer espresso machines. For a list of certified Slayer technicians near you please contact our support department. Incorrect uninstallation may result in ...

    • Routine Backflush - Universal

      Backflush Procedure Backflushing your SLAYER Espresso machine is imperative to routine brew group maintenance. Daily backflushing, + a quick scrub, cleans the group of residual coffee and coffee oil build up. Further reducing excessive wear on ...

    • Long Backflush Procedure - Universal

      Long Backflush - Unclogging Brew Solenoid SLAYER Espresso Machines feature 24vDC 3-Way Solenoid Valves on each group head. The valves are located off the rear of the group neck and are the main gateway for water flowing through the brew circuit. ...