Group Cap Rebuild, Universal

• Related Articles

• Group Magnet Switch Adjustment - Universal

  Group Mag Switch Alignment Objective: Inside the group head is a tongue with a magnet installed on it. This magnet comes in contact with the group switches which send signals to the control board for brewing. Occasionally, those magnets can become ...

• Brew Group Actuator Rebuild - Universal

  Group Actuator Maintenance Time: 5-10 minutes Tools: #3 Philips screwdriver Flathead screwdriver #6 hex key Parts: 46000-53070 Gasket, Teflon 10000-16210 Spacer Food grade lube Procedure Step 1: Remove group cover by loosening the three Philips ...

• Replacing Group Head Gasket - Universal

  Replacing Group Head Gasket Objective: Replace group head gasket per Slayer's recommended Preventative Maintenance schedule. All Slayer espresso machines and preventative maintenance kits feature 58mm x 6.1mm EPDM group head gaskets. Parts: ...

• Single Group Electronics Identification Diagram

  2020 Single Group 1. Display Ribbon Cable 7. Group Cap Magnet Switches 2. Relay Harness 8. Steam Tank Level Probe 3. 24v DC Power 9. Transducer 4. Pump 10. SSR Steam Relay 1 5. Solenoids 11. SSR Steam Relay 2 6. Brew Tank RTD 12. SSR Brew Relay If ...

• Single Group & V3 Steam Wand Rebuild (VIdeo)

  Click the link below to watch a video on performing preventative maintenance on the steam wand Steam Wand Rebuild