Hard Reset Procedure Steam EP

Hard Reset Procedure Steam EP

Turn off breaker switch, and main power

Hold the water button and the toggle button at the same time

Have someone switch on main power, hold until you read "Preset Done"

Turn off the main power, wait 10 seconds, turn on power and you'll see Steam_EP 1.09 and No Serial Number

The screen will revert to switched off menu. From switched off press and hold the encoder knob for 10 seconds.

Set the number of groups

Verify correct transducer type

Insert serial number. Typical serial numbers are 4 digits. Add a zero on the first number then serial number. 

Scroll to exit menu, Press the encoder.

Press the encoder again to initialize machine

From main menu press encoder to "enter menu"

Press the encoder again and scroll to "brew temp offset"

Press the encoder for specific group and enter the offset provided. Please note if the offset is negative. 

Press and hold the encoder to revert to main menu. 

• Related Articles

• Reset Factory Default - Steam Series

  Reset Factory Default - Steam X, LP, & EP Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Resetting to factory default will reset all personal settings. Scroll through the menu settings and record ...

• Hard Reset - Single Group

  Hard Reset, Single Group Step 1: Press circle to enter programming Scroll to Advanced Settings and circle to enter Scroll to menu option Save/Restore settings, press circle to enter Arrow up to Reset Factory Default Press circle, arrow to yes, press ...

• Hard Reset, Steam X

  Steam X Hard Reset This hard reset will send the brain back to factory settings. This means it will lose all information such as serial number and offsets. Therefore, before doing this procedure, record serial number, brew offsets and flow meter ...

• Steam Actuator Adjustment - Steam Series

  Adjusting Steam Actuator - Steam Series Objective: Slayer magnetic steam actuators have two positions: Up is a rinse that should bounce back to the off position. On is a continuous steam actuation. The actuator should index in the center and now ...

• Draining Tanks - Steam Line - Video

  https://drive.google.com/file/d/1FvQf5ljFwdPbu2XVIQK60-M3_9naGr-o/view?usp=sharing