Replacing Display Assembly, Single Group

Replacing Display Assembly, Single Group

Installing New Display Board 

Time: 10 Minutes

Tools Needed: #2 Phillips Screwdriver 
                          Allen Key  

Remove the cup tray and set aside 
Use a #2 Phillips Screwdriver to unscrew the two screws holding the back panel to the machine 
Rock the back panel back and disconnect the ribbon cable from the board 
Remove the back panel and put on a flat surface (note: lay down towels to not scratch the panel) 
Use an Allen key to remove the 4 Allen screws surrounding the display 
Remove the defective display and replace with the new display 
Screw in the 4 Allen screws and plug the ribbon cable back into the circuit board 
Reinstall the back panel by inserting the bottom of the panel and setting  the two bump screws  into the holes then rocking the top of the panel forward.  
The panel should be snug against the firewall of the machine 
Screw the back panel in and turn on machine 

    • Related Articles

    • Display Operation - Single Group

      Slayer Single Group Display Operation Objective: Navigate touch operations of LCD display. Parts: 99004-60120 DISPLAY ASSEMBLY, HOME Tools: Pad of your thumb. The operation of the single group display is best described in the video below. Using as ...

    • Panel Installation - Single Group

      Single Group Panel Installation Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: Install and remove panels for maintenance, service, and panel replacement. Please contact Slayer Tech ...

    • ECR 22030 - Single Group Side Block

      Please see PDF attached for details on changes with the Single Group side blocks. 

    • Replacing Circuit Board Single Group

      Replacing Circuit Board Single Group   Tools Needed: #2 phillips head screw driver, #0 phillips head screw driver. Time Needed: 10 minutes Unplug machine and turn off water Remove Cup Tray Remove the two screws on the back panel under where the cup ...

    • Replacing Transducer Assembly, Single Group Classic

      Slayer Single Group (Classic) transducer replacement UPDATE: Honeywell transducers have been phased out. Please click here for updated instructions. If you still have new legacy Honeywell transducers on hand, see below for replacement instructions. ...