Replacing hot water mix
Remove back panel
Remove side panel
Drop electronics: https://app.frame.io/presentations/1c05af1b-9803-5d53-aea0-6bc4d9764216
Disconnect inlet tubes
Disconnect inlet tube
Disconnect gauge tube Disconnect inlet solenoid
Disconnect clamp, remove drain tray
Related Articles
Blending Hot Water Mix Valve - Steam Series
Adjusting Hot Water Spout Temperature: Steam X, EP, & LP SLAYER Steam Series machines feature a hot water mix valve which blends low pressure (line pressure) inlet water with hot (steam tank) water. The mix valve is a 24vDC solenoid valve and is ...Hot Water Mix Valve Troubleshooting - Steam Series
Hot Water Mix Valve Troubleshooting: Steam X, EP, & LP SLAYER recommends all service be performed by an experienced SLAYER Espresso trained technician. For a technician reference near you, please contact SLAYER Support at (206)-284-7171 (#1 in ...Water Treatment Requirements
Water Treatment Requirements SLAYER recommends water is tested pre-and-post filtration during routinely scheduled Preventative Maintenance. Improper water treatment is the most frequent cause of espresso machine damage. Water is complex and varies ...Slayer Steam Hot Water Button Not Working
Slayer Steam Hot Water Button Not Working 1. Verify that the button is connected 2. Verify the button is not loose from the assembly 3. Raise the hood of the machine 4. Verify the button is seated properly in the carriageReplacing Transducer Assembly, Single Group Classic
Slayer Single Group (Classic) transducer replacement UPDATE: Honeywell transducers have been phased out. Please click here for updated instructions. If you still have new legacy Honeywell transducers on hand, see below for replacement instructions. ...