Setting Pump, V3

Setting Pump, V3

Locate pump
Locate adjustment screw on the right side of brass pump housing
Loosen black lock nut with wrench
Adjust to 10 bar with a blind portafilter in the grouphead by using a flathead screwdriver
    -Clockwise to raise pressure 
    -Counterclockwise to lower pressure 
Re tighten lock nut
Verify pressure by actuating the grouphead to full brew with a blind portafilter inserted

    • Related Articles

    • Setting Rotary Pump on Single Group (January 2020 or later)

      Setting Rotary Pump on Single Group (January 2020 or later) Tools Needed: Flathead screwdriver, Phillips head screw driver, or multi screwdriver (photo) Time Needed: 10 Min Press circle to enter into programming Scroll to pump percentage, confirm the ...

    • Setting Brew Pump Pressure, Single Group

      Setting Brew Pump Pressure, Single Group Press the Circle to enter programming Scroll to brew pump pressure Press circle to bracket pump percentage Install blind portafilter Turn on full brew Increase percentage until the bar pressure on the gauge ...

    • Single Group Pump Reset

      Unplug the machine. Take the cup tray off. Remove the back panel. Follow the wire from the pump to the board. Below is a photo of which port the pump plug goes in. Unplug the pump plug and leave unplugged for two minutes. Plug the pump back in, ...

    • Setting Pump and Regulator Assembly - Slayer Steam X

      Setting Pump & Regulator - Steam X Objective: Steam X was designed with a unique pump assembly that featured an in-line pressure regulator for the brew circuit. This guide will demonstrate how to calibrate this assembly. Time: 15 minutes Tools: ...

    • Pump Port Test, Single Group

      Testing Pump Port on Circuit Board Time Needed: 10 Minutes Tools Needed: #2 Phillips Screwdriver                           Multi meter Step 1: Get to the Circuit Board Remove the cup tray Unscrew the two screws below the display and rock back the ...