Single Group Board Test

Single Group Board Test






With the ribbon cable (top right) being 1. Following counterclockwise to the last connection (bottom right) being 9.





Unplug the machine from the power source


Unplug all connections except 1 and 3.


Plug the machine back into the power source


One by one, plug in connections : 2,4,6,7,8,5


Each time a connection is plugged in, check to see if the machine is on.  


Advise if and when the machine turns off.


    • Related Articles

    • RTD Test, Single Group

      RTD Test, Single Group This procedure tests the resistance of the RTD. The RTD measures the temperature of the brewing group. As the machine fluctuates in temperature, the resistance will change sending a signal to the board to heat or not heat the ...
    • Single Group Board Power Test

      Unplug the machine.  Remove the back panel, being aware of the ribbon cable attached to the screen.  Unplug all the plugs except #1 and #3.  Follow #3 up to the screen and make sure it is attached to the screen, set the back panel to the left side of ...
    • Display Configuration - Espresso Single (Classic)

      Convert Espresso Single display to (Classic). SLAYER recommends all service be performed by an experienced SLAYER Espresso trained technician. For a technician reference near you, please contact SLAYER Support at (206)-284-7171 (#1 in Directory) or ...
    • Group Magnet Switch Troubleshooting - Espresso Series

      Group Mag Switch Troubleshooting - Espresso V3 & Single Group SLAYER recommends all service be performed by an experienced SLAYER Espresso trained technician. For a technician reference near you, please contact SLAYER Support at (206)-284-7171 (#1 in ...
    • Pump Port Test - Espresso Single (Classic)

      Pump Port Test - Espresso Single (Classic) SLAYER recommends all service be performed by an experienced SLAYER Espresso trained technician. For a technician reference near you, please contact SLAYER Support at (206)-284-7171 (#1 in Directory) or ...