Steam X Transducer Change Firmware (1.04 and newer)

Steam X Transducer Change Firmware (1.04 and newer)


This program defaults to read an Eltek transducer. If this program is used to replace an existing Steam X control board we need to switch to read the Honeywell transducer.


If the wrong transducer is chosen in the programming this will cause an over run of the heaters which will blow the pressure relief valve.


Process for changing the transducer:  

1. Hold the toggle encoder from the main menu for 10 seconds to enter into the technician programming.

2. Scroll to "Max Pressure"

3. 2Bar is Eltek, 100PSI is Honeywell.

4. Identify the current Transducer

5. Set the "Max Pressure" Accordingly.


All boards sent out must identify which transducer the customer is using and program accordingly.

    • Related Articles

    • Slayer Firmware Update - Steam Series

      Slayer .hex Firmware Installation Instructions Revised 6/12/2023 Authorized Slayer technician's firmware update field guide. Items Needed: Firmware Programmer & Cables (Image Below) Atmel Studio 7 (Microchip Studio) installed on a Windows compatible ...

    • Replacing Transducer Assembly, Single Group Classic

      Slayer Single Group (Classic) transducer replacement UPDATE: Honeywell transducers have been phased out. Please click here for updated instructions. If you still have new legacy Honeywell transducers on hand, see below for replacement instructions. ...

    • Eltek Transducer Retrofit - Steam Series

      Slayer Steam & Steam X Technician's retrofit guide for Slayer Steam Series. Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: Update legacy Steam Series machines to current Eltek ...

    • Eltek Transducer Retrofit - Single Group Classic

      Slayer Single Group (Classic) transducer retrofit guide Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: Update legacy Single Group machines to current Eltek transducer assembly. ...

    • Verify Firmware - Steam Series

      Verify Firmware - Slayer Steam X, EP, & LP Objective: Identify operating firmware for diagnosis, hardware compatibility, and machine features. There are several hardware retrofits, improvements, and bug fixes which come as a result of upgrading ...