Verifying Correct Transducer Setting EP
Verifying Correct Transducer Setting
Time: 5 min
Tools: none
Scroll to "Switch Off", press the toggle, scroll to yes and switch off.
From the Switched Off menu press and hold the toggle for 12 seconds
Once in the production menu, scroll to Xducer type (transducer type)
Confirm the transducer type.
Confirm the transducer type
Scroll to exit menu. Press the toggle.
Press the toggle to initialize the machine.
Related Articles
Replacing Transducer Assembly, Single Group Classic
Slayer Single Group (Classic) transducer replacement UPDATE: Honeywell transducers have been phased out. Please click here for updated instructions. If you still have new legacy Honeywell transducers on hand, see below for replacement instructions. ...
Eltek Transducer Retrofit - Single Group Classic
Slayer Single Group (Classic) transducer retrofit guide Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: Update legacy Single Group machines to current Eltek transducer assembly. ...
Replace Eltek Transducer
Tools Needed: #2 Phillips, Razor Blade, Tape, 1/2" wrench, Large adjustable wrench. Time Needed: 15 Min Turn off the machine and unplug Turn off the water Open steam valve to ensure steam pressure is relieved from the system, or open drain valve to ...
Eltek Transducer Retrofit - Steam Series
Slayer Steam & Steam X Technician's retrofit guide for Slayer Steam Series. Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: Update legacy Steam Series machines to current Eltek ...
Hard Reset Procedure Steam EP
Hard Reset Procedure Steam EP Turn off breaker switch, and main power Hold the water button and the toggle button at the same time Have someone switch on main power, hold until you read "Preset Done" Turn off the main power, wait 10 seconds, turn on ...