Wood Cup Tray - Espresso Series

Wood Cup Tray - Espresso Series



Espresso V3 & Single Group Wood Cup Rail Dimensions




Espresso Single Group:
  1. Standard Configuration:
    1. 2.125"
    2. 13004-10050 CUP TRAY ASSEMBLY, SINGLE GROUP
  2. Wood Cup Tray:
    1. 4.87"
Espresso V3:
  1. Standard Configuration:
    1. 2.75"
    2. 13000-10050 CUP TRAY LOWER, 2 GROUP, STANDARD [FINISH]
    3. 13000-13050 CUP TRAY LOWER, 3 GROUP, STANDARD [FINISH]
  2. Wood Cup Tray:
    1. 4.64"
Standard deviation +/- 0.1".

Supplemental Cut Sheet Measurements:
  1. SLAYER Installation Cut Sheets
Installing a wood cup tray increases the rear height of the machine by several inches. Measurements taken from rear panel to X leg without rubber feet installed.
Espresso Single Group:
  1. Standard Configuration: 12.75"
  2. Wood Cup Rail: 15.5"
Espresso V3:
  1. Standard Configuration: 17"
  2. Wood Cup Rail: 18.89"
Steam Actuator Handle Height (measured in OFF position):
  1. Espresso Single Group:
    1. 14.5"
  2. Espresso V3:
    1. 19"

Questions or concerns? Please contact support@slayerespresso.com

    • Related Articles

    • Drip Tray Reservoir Installation - Single Group (Classic)

      Drip Tray Reservoir Installation Slayer recommends that all service be performed by an experienced Slayer Espresso trained technician. Objective: The following guide demonstrates removal of standard configuration drip tray liner and installation of ...

    • Extraction Dial In - Espresso Series

      Espresso V3 & Single Group Dial-In Coffee Extraction SLAYER Espresso Series machines feature a precision Needle Valve which controls the flow rate of water during the Pre-Brew phase of an extraction. This flow rate control allows the barista to ...

    • Pre-Brew Calibration - Espresso Series

      Pre-Brew Flow Rate Calibration - SLAYER V3 & Single Group Do not tighten Needle Valve below the 40g/30s threshold. Important: Over-tightening the valve may damage or break the needle inside. Only adjust the flow rate incrementally. SLAYER Espresso ...

    • Group Magnet Switch Troubleshooting - Espresso Series

      Group Mag Switch Troubleshooting - Espresso V3 & Single Group SLAYER recommends all service be performed by an experienced SLAYER Espresso trained technician. For a technician reference near you, please contact SLAYER Support at (206)-284-7171 (#1 in ...

    • Brew Gauge - Espresso Series

      Brew Circuit Gauge Characteristics & Troubleshooting - Espresso V3 & Single Group Each group on a SLAYER Espresso V3 & Single Group features a gauge connected directly to the brew tank. Brew gauges indicate several hydraulic brew circuit states: idle ...