LP
Flow Rate Test
First: is your flow rate from your filtration consistent? Have you changed your filters lately? What does the gauge read on the filtration for output pressure? Are you receiving 1.5-2 GPM? or 40-60psi? Lets make sure the pump is set properly. Insert ...
Steam X Transducer Change Firmware (1.04 and newer)
This program defaults to read an Eltek transducer. If this program is used to replace an existing Steam X control board we need to switch to read the Honeywell transducer. If the wrong transducer is chosen in the programming this will cause an over ...
110c Thermostats
Part: 110c thermostat Purpose: A thermostat is a safety feature that cuts power to the element if the thermostat is tripped by overtemp. The thermostat is tripped by sensing direct heat contact with boiler. Slayer upgraded the brew tank thermostat ...
Setting Brew Pump Pressure, Single Group
Setting Brew Pump Pressure, Single Group Press the Circle to enter programming Scroll to brew pump pressure Press circle to bracket pump percentage Install blind portafilter Turn on full brew Increase percentage until the bar pressure on the gauge ...
Crating
Crating Instructions Drain all boilers Steam Tanks Groups Preheat [Espresso only] Set the crate bottom on top of the crate top Remove feet from the machine: All 4 feet on the Slayer Steam. Two on the Slayer V3 and Single Group. Front Right and Rear ...
Replacing Slayer Steam Display Screens
Step 1: Turn off machine and unplug from power We will need to “raise the hood” for the top cover. Lower the actuator handles, remove the screws that attach the top cover to the body, turn the steam wands and hot water wands to face the inside of the ...
Single Group Board Test
With the ribbon cable (top right) being 1. Following counterclockwise to the last connection (bottom right) being 9. Unplug the machine from the power source Unplug all connections except 1 and 3. Plug the machine back into the power source One by ...